ASI¶
media.ingest.asi
Description¶
ASI carries MPEG-TS through a physical connector, while SDI carries uncompressed video. To ingest an ASI signal in Sapsan, use an external ASI-to-network gateway and configure a MPEG-TS network input.
Configuration¶
Configure the gateway to send MPEG-TS to the receiving streamer. Configure the corresponding UDP input in Sapsan:
streams:
- name: asi_gateway
inputs:
- udp:
host: 0.0.0.0
port: 5000
Parameters¶
The host and port values belong to the network receiver. The gateway’s card, connector and ASI mode are configured on the gateway.
Transport options¶
The gateway receives physical ASI and sends MPEG-TS over UDP. Sapsan receives the network MPEG-TS stream.
Supported codecs¶
See the MPEG-TS codec list. The gateway must preserve the transport stream and its service information.
Error handling¶
Check the signal on the ASI connector, the gateway destination and network delivery. Diagnose the receiving stream with MPEG-TS input counters.
Applying changes¶
Apply the network input configuration through the central API and check input state and arriving frames.
Counters¶
Use network MPEG-TS input counters. Card inventory describes the hardware connected to the server.
Other details¶
ASI depends on the firmware mode and physical port direction. A BNC connector alone does not identify the signal type.